The Workings of the Motor Starter (part 2)

2. At full regard pinion

Starter motor started playing
When the pinion gear is fully associated with the ring gear, the contact plate will begin to close the play switch, see figure above. At this current will flow as follows:
Battery - terminal 50 - hold in coil - mass
Batteries - play switches - terminal C - field coil - anker - mass

As in the picture above there is a current in terminal C, then from the pull-in coil current can not flow, resulting in the contact plate being held by the hold-in coil magnetism alone. At the same time a large current will flow from the battery to the coil mass anker field through play switches. Consequently starter can produce a large torque that used rotating ring gear. When the motor is started living, the ring gear will rotate through the pinion anker. To avoid damage to the starter due to these conditions, the starter clutch will hold harmless and indemnify anker of excessive rotation.

The Workings of the Motor Starter (part 1)

1. At Starter Switch ON

Motor starter at the position "start on"
When the starter switch is turned ON, the battery current flows through the coil to hold mass in the other hand and pull in coil, field coil and to the masses through anker. At this time hold and pull-in coil form a magnetic force in the same direction, because the direction of the current flowing in the two coils. From this incident contact plate (plunger) will move toward closing play switch, thus shifting the starter drive clutch lever moves toward the position relating to the ring gear. To more clearly the current flow is as follows:

 Battery - terminal 50 - hold in coil - mass
 Battery - terminal 50 - pull-in coil - field coil - anker- mass

Therefore, the current flowing into the coil field at that time, relatively small then anker spin slower and allow docking with the ring gear pinion becomes soft. In this situation the contact plate switch has not closed games.

BAGIAN-BAGIAN PENTING DALAM SISTEM PENGAPIAN

 Komponen-komponen penting pada sistem pengapian menggunakan platina

1. Charge Coil (Spul)

Fungsinya untuk mengisi kondensor dengan muatan listrik 

2. Fly Wheel Magneto

Fungsinya untuk membangkitkan listrik .

3. Platina

Fungsinya